Thank you for any help.Brand New Small Business installing 150 AX. 3 total. Can location/radio interference cause an issue?I have one location that will not obtain IP address(red,green,off) I can change the units (use different Access Points), take...
Hello, My Dmvpn hub doesn't have any nhrp state, yet the spoke is stuch in NHRP The hub config is here The spoke config is here I will appreciate your help
Good morning!I have a cisco 9501 that i am setting up as the WLC. I used the air provision ssid for setup. It broadcast the new ssid but when i connect to the new ssid i cannot access the portal page for the wlc. i also cannot access the portal from ...
Hi guys, I have a problem to configure VPN IPSec tunnel with Ikev2.I have already an IPSEC VPN Ikev1 configured, up and running, and I need to configure a new one with IkeV2. I have tried to configure but , during the crypto isakmp debug I received ...
I have version 2.7. I suspect the problem might be something with the certs since when I had it joined to the cluster I could not view the certs on ise2. When I log into the gui it just sits on /admin/LoginAction.do. Is there a way i can remove the c...
Looking for recommendations for routing traffic from ASA back to router on "inside" network so we do not have to add static routes on systems. We recently added an ASR1001 to our "inside" network that routes traffic to Amazon thru a Megaport link tha...
I'm new on this job and I have been trying to correct a lot of wireless issues. I've added more wired APs and upgraded a lot of APs off the old 5500 controller. I'm not going to say I'm a wireless guru because I'm not, but I am able to configure APs ...
Hi everyone,I am trying to recover the console password of a Cisco Nexus 3000; however, for some weird reason, whatever I am trying is not working. Using CTRL + C, I am able login to the “switch(boot)#” The switch does not take the command “dir” I tr...