Hello, I create Ikev2 site to site tunnel between two cisco FPR 1140. I have same subnet on both location and i used source and destionation NAT in one site. My user try access over web some aplication and it is work, but when other site try to acc...
Hi Everyone!I’m trying to use the Dynamic Access Policy in Cisco FMC to create a RA policy for specific VPN profiles.I’m trying the new FMC DAP option under Device/VPN/DAP.Have someone ever used this feature to create a policy like this:If the user s...
I just bought a brand new CP-8841-3PCC-K9 IP phone from an online dealer here in Germany.When trying to connect the phone to my router fritzbox 7490 I get a starting picture on the phone asking me to "enter activation code". Just that, not "enter act...
Hi, I recently purchased a new 8861 3pcc K9. It is asking for an activation code. I purchased this phone for my small business and I'm the only user. I can NOT figure out how to find this code or get past this. Thanks in advance for your help.
Hi We have to configure a RB VPN and am wondering if I add the new VTI Interface to The exsisting outside security group or do I have to create a new security group, the outsdide Security group has the Internet facing Interfaces in it.??Thanks
How do I set up a Static default route for a particular vlan on a RV34x series router? I am trying to send all traffic from a particular subnet over the VPN. As of now only traffic destined for the VPN network will go over the VPN but I want ALL traf...
IntroductionValidated DesignTraffic Flow in Cisco Wireless SD-Access solutionMeraki Wireless Design FundamentalMeraki Device-to-Cloud CommunicationsLab SetupConfigurationValidation Introduction With the evolution of software defined networking (SD...
This is a very strange one, Our SSL inspection suddenly started to fail across our (ASA+SFR) environment. - We deployed SSL inspection about 2 years ago, and had no issues till now. The Symptoms we're seeing are - Under the events: SSL Flow error: ...
Hello Team, I hope you are doing well!I'm trying to implement PBR on Industrial switch IE-3400. I used the how to below, but the result was not ok.https://www.cisco.com/c/en/us/td/docs/switches/lan/cisco_ie3X00/software/17_3/b_ip_routing_17-3_iot_sw...
HIIs it possible for me to manage switches thats are not part of our SDA Fabric, they are in a dufferent part of the Network, i would like to manage these via DNAC so I could use DNAC to upgrdae Images etc, if its possible could someone tell me how ...
On servers I've set up recently, I'm getting Out Of Range messages during boot. I get the Dell "BIOS splash screen" for a few seconds, and then it's Out Of Range until partway through Windows showing the spinning wheel. This is causing problems, bec...
If a frame with a tag corresponding to the native VLAN enters the trunk port, will the switch take down that frame and send it on over the trunk link as untagged, or will it send it with a tag corresponding to the native VLAN?How I understand it:(Let...
I have Cisco ASA 5505 firewall on wich I wanted to install pfsense. First problem I had was to small CF(128MB) so I went and bought CF with 8GB of space. I used old computer to install pfsense on this CF, and I then noticed that pfsense is using ZFS ...
Hi,how to manually enable the R flag (R-bit) in ipv6 config, let us say in a cisco csr1000v?I have this documentation:https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipv6/command/ipv6-cr-book/ipv6-i3.html#wp1103499300but unfortunately I could only ...